1.A connecting link of an O-ring Chain for standard application is pre-coated with grease in the pins. Prior to connection, verify the grease within the surfaces of pins, and in case the level of grease is modest, apply grease with bare hands. (If gloves are made use of, the grease will probably be absorbed by the gloves.)
Instance: Once the connecting website link (I) of an O-ring chain for common application is
shipped, O-rings are fitted with the roots on the pins. If your O-rings come loose as a result of vibration for the duration of transport, refit the O-rings in to your roots of the pins.
In this instance, make sure you return the grease collected in the roots in the pins towards the central surfaces in the pins, much more at portion A than at portions B shown within the over illustration. (Portions A is worn due to sliding with the bushings.)
2.The chain could be most very easily connected to the teeth of a sprocket. Engage the back links at each ends on the chain using the sprocket teeth and match connecting pins. In case the sprocket may be moved, the chain may also be linked within the loosened side.
3. Connecting procedure
one.Confirm that O-rings are connected to the roots in the pins.
2.In the event the amount of grease applied to the connecting pins is tiny, coat the pins with grease in the central portions.
3.Insert the connecting pins in to the bushings on the inner links at each ends.
four.Confirm the grease is applied towards the complete encounter of your O-ring, and fit the O-ring onto the connecting pins.
5.Insert the connecting pins into the connecting plate and when pressing the connecting plate, install the spring clip. Confirm irrespective of whether the head (the end without a split) of your spring clip is turned while in the feeding route with the chain. (See the next illustration.)
six.Make sure you confirm that the spring clip is securely fitted in the clip grooves from the connecting pins.
This completes jointing from the connecting hyperlink. Note that grease to the surfaces of connecting pins and O-rings is often eliminated during installation function. In this instance, re-grease employing the grease about the surface of the base chain or even the grease while in the polyethylene bag through which the connecting link was contained.