Electrical power UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is developed solely for that small lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit has become extensively employed in the marketplace of logistic devices such as minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is controlled through the solenoid valve together with the velocity managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
General Description
This energy unit is developed solely for that medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and also the speed managed by the adjustable needle valve. When the lift rises to a large positoin, but the electrical power supply is cut, the reducing motion is managed by the guide override function.
Energy UNITS FOR LIFT TABLE 3
Common Description
This electrical power unit is built solely for your big lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as speed managed by a pressure compensated movement control valve.
Power UNITS FOR LIFT TABLE 4
General Description
This energy unit is designed solely for your huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as the pace controlled by the adjustable needle valve. When the lift rises to a substantial positoin, but the power provide is minimize, the lowering motion is controlled through the manual override perform.
Unique Notes
1. This power unit is of S3 duty cycle, which may only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean every one of the hydraulic parts concerned in advance of installation of the power unit.
3. Viscosity with the oil shoud be 15~46 cst,which really should also be clean and free of impurities.N46 hydraulic oil is suggested.
4. Oil shifting is needed following the first 100 operation hrs,afterwards after each 3000 hrs.
five. The energy unit proven is made to be mounted vertically.