C Kind Flex-Flex Couplings
The C Form coupling includes two flex hubs, a single sleeve and a single accessory kit consisting of seals and snap rings.
CFR Form Flex-Rigid Couplings
The CFR Variety coupling consist of a single flex hub, one rigid hub, a single sleeve, 1 accessory kit consisting of seals and snap rings.
Characteristics
Uncomplicated and cheap variety of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in place
Offered as vertical and horizontal couplings
Wide assortment of distinctive variations for example full-flex, flex-rigid mill motor
Standard configurations can be found on the shelf
Ordering Information and facts
Application: Driver and Driven.
Type and dimension of coupling, horizontal, vertical and so forth.
Energy: Motor horspower or torque requirement.
Velocity: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Shaft sizes.
C and CFR Sort Couplings
Ordering Facts
Puller Holes are normal on sizes four by means of twelve.
Puller Holes are available for sizes 7/8 by three.five at an extra charge.
The BSE (distance Concerning Shaft Ends) could fluctuate in between G and G1.
Interference bores without any set screws are regular unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek advice from Engineering Part.
Bigger sizes are available, please seek advice from Technical Help.