SMR Gearbox Installation
Satisfactory effectiveness depends on right set up. lubrication and servicing. consequently it’s important that the instructions from the set up and servicing leaflet. provided with each gearbox. are followed cautiously. a number of the essential aspects of belt and torque-arm set up are listed under.
1. Install pulley on gearbox input shaft as near to the reducer probable, and mount reducer on driven shaft as near to bearing as useful. failure to try and do this may induce excess loads in the input shaft bearings and output bearings 
and could cause their premature failure.
two. Install motor and wedge belt drive with the belt pull at roughly 90° towards the center line amongst driven and input shafts. this can allow tensioning in the wedge belt drive together with the torque arm which really should ideally be in stress. if output hub runs anti-clockwise. torque arm ought to be positioned the correct.
three. lnstall torque-arm fulcrum on the rigid help to ensure that the torque-arm will probably be at about suitable angles for the center line with the driven shaft as well as torque arm case bolt. be certain there is certainly enough consider up while in the turnbuckle for belt stress adjustment.
Keep close.
Bell drive could be located in any handy postion. when the torque arm is usually to be utilised to tighten the belts, the drive really should be at about tight angle for the line between the input and output shafts.
Bell drive might be located to your appropriate if wanted.
If output hub rotates clock-wise. place belt drive and torque arm in opposite path to that proven during the illustration.
Torque arm and belt get up.
Torque arm could be mounted on the correct if desired.
